Quantum SCSI Settings
The pins located in the lower left corner of the drive set up the SCSI ID. Each device on the SCSI bus must have a unique SCSI ID assigned to it. The Quantum VP32210 can be configured for ID's 0-7. To set the SCSI ID number, use only these three pin pairs. Leave the remaining jumpers set in their positions.
Jumper Location
| SCSI ID |
PINS 1-2 |
PINS 3-4 |
PINS 5-6 |
| 0 |
Off |
Off |
Off |
| 1 |
On |
Off |
Off |
|
| 2 |
Off |
On |
Off |
|
| 3 |
On |
On |
Off</> |
|
| 4 |
Off |
Off |
On |
|
| 5 |
On |
Off |
On |
|
| 6 |
Off |
On |
On |
|
| 7 |
On |
On |
On |
|
|
Do you have questions, comments or suggestions regarding the format of this page? If so, drop a line to the Internet Editors . Any feedback would be MUCH appreciated!
Please note: If you have questions of a TECHNICAL nature or need TECHNICAL assistance, please contact technical support here as the Internet Editor address does not reach a Gateway support technician. Questions of a technical nature or requesting technical assistance cannot be responded to via the Internet Editor address.
|
